aluminum-matrix
基本解釋
- 鋁基
英漢例句
- The aluminum matrix composites with TiB2 reinforcement are manufactured by squeeze-cast method.
采用擠壓鑄造方法制備了TiB2增強鋁基復合材料。 - Aluminum matrix ceramic coating was fabricated on Q235 steel by thermochemical reaction method.
采用熱化學反應法在Q235鋼上制備氧化鋁基陶瓷涂層,對涂層進行結構分析及性能測試。 - The wear of aluminum matrix composites,which is the common result of spall,adhesion and particle wear,is analysed in the end of the paper.
最后分析了鋁基復合材料表面的磨損情況,說明了它的磨損是剝落、粘著和磨粒磨損共同作用的結果。 - Abstract: The squeeze casting technology was used to manufacture gradient aluminum matrix composite reinforced by ceramic fibers,and metallographic structures and therma l properties of the composites were studied.
文摘:采用擠壓鑄造法制造陶瓷纖維增強梯度鋁基復合材料，通過觀察其金相組織、測試其熱學性能，并對梯度復合材料活塞頂?shù)臏囟确植技案魺嵝ЧM(jìn)行了計算。 - By injecting KBF4+Ti powder into molten Al and rapidly stirring,it has been shown that TiB_2 particulates reunion on grain boundary disappear and TiB_2 particulates(less than 0.5um) uniformly distribute in the aluminum matrix composite.
結果表明:通過氬氣流載入反應混合粉;并快速攪拌熔體;可克服TiB2顆粒在晶界的團聚;細化顆粒;獲得顆粒小于0.;5um、且較均勻分布的TiB2/Al復合材料。