crystallization point

基本解釋

There are many pores in the sinter, which is attributed to low melting point and crystallization capacity of the binding phase.
低氟燒結礦中存在大量微氣孔是由于其粘結相的熔點和結晶能力低造成的。
In addition, high draw ratio will increase the melting point and crystallization rate of the soft segments for both types of segmented copolymers.
此外，高倍拉伸會提高上述二類多嵌段共聚物中軟鏈段結晶的熔點和結晶速率。
This paper studies extracting glutamic acid of the second isoelectric point crystallization from the deposited equipotential mother solution through evaporation and concentration.
本文介紹了等電母液除菌后，蒸發濃縮二次等電結晶提取谷氨酸。

結晶點
Melting point and crystallization point of the raw products were measured, melting point 49.8℃, crystallization point 47.48℃. The stability and repetition of the synthesis experiment were measured and were satisfying, average yield of products in these experiments was over 95%.
在該工藝條件下，氯苯轉化率可達100％，反應選擇性為95.4％，以氯苯量計，產率為95.4％，粗產品中2，4-二硝基氯苯含量為96.39％；對粗產品的熔點和結晶點進行了測定，其熔點為49.8℃，結晶點為47.48℃；對合成實驗的重復性和穩定性進行了驗證，其產率均在95％以上，實驗的穩定性和重復性較好。