cone angle

基本解釋

That cone angle is directly controlled by the focal length.
圓錐角度直接受到焦距的控制。
The tensile strength, zinc coat mass and service life of die of galvanized steel wire after drawing are compared on the condition of different work cone angle.
在不同的工作錐角度下，比較鍍鋅鋼絲拉拔後的抗拉強度、鋅層質量、模子壽命。
You unhappy is the most unhappy, I could give up a lot of things can be the feel unimportant, but when I actually stood cone angle of life, I am sure, not so free and easy, really!
你的不開心才是我的最大不開心，可能很多事情可以放棄，可以覺的不重要，但儅我真的站在人生的錐角，我肯定沒那麼灑脫，真的！

Wide Viewing Angle: With a viewing cone of 180 degrees, the M3D technology overcomes the disadvantages of conventional displays when it comes to off-axis viewing.
ENGADGET: Phosphor's Reveal wristwatch uses Swarovski crystals to tell time, bedazzle you

錐角
The sizes of open-die cold extrusion of deep thin cone-hole were predicted,the curve form of the hole and the theoretical curve between the cone angle of the rough and the hole angle were gained.
對開式冷擠壓深小錐孔的尺寸進行了預測,得到了內孔母線曲線形式及坯料外錐度與內錐孔錐角的理論關系曲線。
機械工程
錐度
The stress concentration will be the minimum when the cone angle is in the range of 2° to 10°.
計算結果表明:錐度控制在2°～10°之間,接頭中的應力集中最小。
圓錐角

錐角
With the enter flow and bottom diameter of the equipment going up, the velocity will increase. But With height and cone angle increasing, the velocity will decrease.
增大裝置進流量和底孔孔逕時流場內各曏流速相應增大;增加高度和錐角時流場內各曏流速相應減小。